23425
AVR10/AVR20/AVR30/AV40 Software Release Notes
– 12 –
Arcam, The West Wing, Stirling House, Waterbeach, CB25 9PB, UK
Host Version 1v10/09
LCD/IAP 0.50/0.04
DSP1 02.01 / 01.19
DSP2 00.01 / 00.17
DTS 3.90.50.1
OSD 0.03
DAB 303 / 561
NET 0.100.406
BT 0.7 (or higher, depending on build)
Fix list:
IMS20890: IMAX fixes applied.
IMS20955: Show streaming service logo & MQA logo when using Cast.
IMS21115: PS4 2 channel PCM using Virtual:X could cause audio artefacts
IMS21118: Sampling frequency incorrectly shown for analogue processing modes.
IMS21136: Sub trim does not show on OSD
IMS21208: When in standby, control commands for input switching should respond with 0x85
IMS21310: Bi-amp L/R speakers not recognised by Dirac calibration tool.
IMS21363: Cannot set display brightness over RS232/IP
IMS21369: When Dirac is enabled, speaker distance should show “mS”.
IMS21371: Audio button toggles filter1, filter2, filter3, off.
IMS21372: Menu > Speaker Distance Sub shows as “Channel 12”
IMS21375: No OSD popup when Dirac EQ selected.
IMS21378: Dirac filters optimisation.
IMS21383: Start Dirac, unit would occasionally not got into Dirac measurement mode
IMS21384: Report Subwoofers as “sub” not LFE in Dirac calibration tool.
IMS21390: OSD shows “centre” and “analogue” when region set to US/Canada.
IMS21396: Start Dirac if on the NET input, test tones only come out of FL0
IMS21409: Audio button recalls current state on first press, then changes.
IMS21437: Cannot set IMAX Enhanced mode over RS232/IP
IMS21447: Editing name on unit after setting with web GUI causes crash
IMS21453: Dirac master volume level starts at incorrect level
To Next Page
Loading...
