Need help?Do you have a question about the Arcam AVR300 and is the answer not in the manual?
Setup diagrams for FM, RDS, and AM measurements using signal generators.
Procedures for calibrating amplifier channels and idle current.
List of components for the Power Amp 1 assembly.
General| Type | AV Receiver |
|---|---|
| Audio Channels | 7.1 |
| Power Output | 100 W per channel (8 ohms) |
| Component video inputs | 3 |
| Component video outputs | 1 |
| Dolby Digital | Yes |
| DTS | Yes |
| Input Sensitivity | 200 mV |
| Input Impedance | 47 kOhms |
| Video Inputs | 5 |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | 100 dB |
To Next Page
