E-32
System
Screen Saver –sets the duration of a static
image display before the screen saver is
shown. The options are: 5/10/15/20/25/30
Minutes or Off. Pressing any button on
the unit or remote deactivates the screen
saver.
/
Disc Auto Playback – controls whether
an optical disc (e.g. BD, DVD, CD) will play
automatically after it has beed loaded or
after the Solo is turned on.
< On: Optical discs will play
automatically.
< Off: play must be pressed to play a
disc.
CEC – The Consumer Electronics Control
(CEC) option is used to allow all supported
devices connected by HDMI to work
together as a single system.
CEC may be turned ‘On’ or ‘Off’, to link or
unlink the supported devices.
Firmware Update – If the Solo is
connected to the Internet, you can check
for an upgrade to your unit’s firmware by
selecting this menu item and pressing
OK to highlight ‘Network’, then press OK
again.
A message appears if no new firmware is
available, otherwise follow the on-screen
instructions. A message tells you when the
upgrade is complete.
Load Defaults – Press OK with this item
highlighted to reset all system settings
to factory defaults (including parental
controls, radio presets, paired device, etc.).
You are asked to confirm that you want to
load the factory default settings. For ‘No’
press OK; for ‘Yes’ press
<
then OK.
System Information – Highlight this
option and press OK to display system
information.
The System Information panel shows
information about your unit, such as the
product name, firmware version, MAC
addresses and support information.
BD-Live Storage – This option allows you
to review or delete BD-Live data stored on
an external USB drive.
The options are:
< Information: Highlight and press
OK to show file information on the
BD-Live data.
< Erase data: Highlight and follow the
on-screen instruction to erase BD-Live
storage data.
/
NETWORK MEDIA – The Solo is capable of
playing UPnP content. Note that the Solo
movie will paly both audio and video files,
whereas the Solo music will play audio
content only. This features can be disabled
by setting it to Off.
Settings Menu
System
System
Auto Standby
System
Load Defaults
Auto Standby
[select option]
B C
B C
B C
B C
B C
B
C
OK
E
D
System
Disc Auto Play
System
System Info
System
Firmware Update
System
Network Media
Disc Auto Play
[select option]
Load Defaults
[select option]
Network Media
[select option]
E
D
E
D
E
D
E
D
5 minutes
10 minutes
15 minutes
20 minutes
25 minutes
30 minutes
Off
Software Version
WiFi MAC
Wired MAC
IP Address
B
C
B
C
B
C
On
Off
Cancel
OK
On
Off
System settings diagram applies to
To Next Page
Loading...
