Arcan HJ3000 - User Manual

1 rev. 05/08/2020
Model HJ3000
3 Ton Aluminum-Steel Hybrid Jack
For Technical Questions, Call: 1-800-879-7316
WARNING INFORMATION
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsiblity of the
device owner to keep this manual intact and in a convenient location for all to see and read. Contact Arcan for a replacement label if your
jack's label is not readable.
THE NATURE OF HAZARDOUS SITUATIONS
The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the device
who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when servicing motor vehicles
and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads,
overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not intended.
METHODS TO AVOID HAZARDOUS SITUATIONS
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack before each use. Do not use jack if damaged, altered, modied, in poor condition, leaking hydraulic uid, or unstable
due to loose or missing components. Make corrections before using.
• Lift only on areas of the vehicle as specied by the vehicle manufacturer.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (Users & Bystanders).
• Do not use jack beyond its rated capacity. Do not shock load.
• This is a lifting device only. Immediately after lifting, support the vehicle with jack stands capable of sustaining the load
before working on the vehicle.
• Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering operations.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Do not move or dolly the vehicle while on the jack.
• Do not use any materials that may serve as risers, spacers or extenders between the stock lifting saddle and the load.
• Do not use any adaptors that replace the stock lifting saddle unless approved or supplied by the jack manufacturer.
• Do not use (or modify) the product for any other purpose than that for which it was designed without consulting the manufacturer's
authorized representative.
• Always lower the jack slowly and carefully.
• Failure to heed these warnings may result in fatal personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer and
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING
WARNING
WARNING
WARNING

Summary

Safety Warnings and Precautions

Nature of Hazardous Situations

Identifies inherent hazards in using portable automotive lifting devices.

Methods to Avoid Hazardous Situations

Provides guidelines to prevent personal injury and property damage.

Consequences of Not Avoiding Hazardous Situations

Outlines risks associated with ignoring safety instructions and methods.

Inspection and Setup Procedures

Inspection

Details pre-use checks for hydraulic jack condition and safety.

Setup

Provides instructions for assembling and preparing the hydraulic jack.

Operation, Maintenance, and Storage

Operating Instructions

Step-by-step guide for lifting and lowering vehicles with the jack.

Preventative Maintenance

Details care procedures to prevent wear and ensure longevity.

Proper Storage

Recommendations for storing the jack to protect it from damage.

Hydraulic Maintenance Guide

Regular Maintenance

Details monthly lubrication and tightening of jack components.

Parts List and Diagram

Specifications and Warranty Information

Specifications

Technical details of the jack's capacity, dimensions, and performance.

Limited Warranty

Information regarding the product's warranty coverage and terms.

Arcan HJ3000 Specifications

General

Brand	Arcan
Model	HJ3000
Category	Jacks
Language	English