Step 5: Remote Installation
1. Battery
• Remove the two screws from the battery door cover using a 1.5mm hex driver.
• Insert the 10440 li-ion battery.
• Check that the 37x1.5mm o-ring is properly seated around the battery door.
• Close the door and tighten the screws.
2. Remote Installation
• Mount the remote to your own MatchMaker compatible parts or using the
clamp provided, ensuring it is in the optimal position and is tightened securely.
Step 6: Remote/Shifter Programming
This process is only required once. The shifter will learn the unique ID of the remote
and only respond to that remote during normal operation. Once the shifter is
programmed, the following steps will not need to be performed again unless you
get a new remote.
• Make sure the shifter and remote are powered off.
• Power on the shifter and pair with the mobile app.
• Go to “Settings > Pair Remote”, tap Proceed. Shifter will turn off automatically.
• Close the app.
• Turn shifter back on. An orange LED will ash indicating Remote Learn Mode.
• Turn on the remote. LED will ash green 2 times, then orange. Once the orange
light has stopped ashing the remote has been uniquely paired to the shifter.
To Next Page
Loading...