Optima 40 24
OPTIONAL BAY DOOR INSTALLATION
Installation of the Bay Door Option does not change any clearances stated on the rat-
ing plate/ or Installation Operation and Maintenance Manual accompanying the appli-
ance.
NOTE: Ensure that the Heater is turned off and cool.
To install this Bay Door Accessory and Knob Extension Kit use the following instructions:
1 Remove the upper grilles by pulling the assembly forward.
2 Remove the lower grilles by removing the four hex head mounting screws that secured
the brass hinges to the unit.
3 Discard the Upper and lower grilles (they are not required for Bay door installation).
4 Install the Hi/Low, On/Off and sparker extension knobs onto the corresponding knobs on
the valve.
5 Move the Bay Door over the front of the insert, line up the slots in the upper area slightly
above the corresponding tabs at the front top of the firebox, and push the assembly
down.
6 Parts supplied with the kit: BBAY 40 door assembly,
308-0094 Hi/Lo Extension Knob
308-0095 On/Off Extension Knob
308-0096 Piezo Extension Knob
7 The lower (center) hinges down for control access.
WARNING: THE OPTIONAL BAY DOOR BBAY–40 IS A DECORATIVE OPTION ONLY
AND IS MANUFACTURED WITH TEMPERED GLASS. THIS UNIT MUST NOT BE OPER-
ATED WITHOUT THE FLAT CERAMIC GLASS DOOR SECURED IN PLACE, BEHIND IT.
To Next Page
Loading...
