21
Engine/Transmission
This section has been organized into sub-sections which
show a progression for the complete servicing of the Arc-
tic Cat ATV engine/transmission.
To service the center crankcase halves, the engine/trans-
mission must be removed from the frame. To service
top-side, left-side, and right-side components, the
engine/transmission does not have to be removed from
the frame.
NOTE: Arctic Cat recommends the use of new gas-
kets, lock nuts, and seals and lubricating all internal
components when servicing the engine/transmis-
sion.
SPECIAL TOOLS
A number of special tools must be available to the techni-
cian when performing service procedures in this section.
Refer to the current Special Tools Catalog for the appro-
priate tool description.
NOTE: Special tools are available from the Arctic
Cat Service Parts Department.
Description p/n
Crankcase Separator/Crankshaft Remover
0444-152
Magneto Rotor Remover Set
0444-254
Oil Filter Wrench
0644-389
Piston Pin Puller
0644-328
Spanner Wrench
0444-251
Surface Plate
0644-016
V Blocks
0644-535
To Next Page