Arctic Spas Y Series - Page 20

Arctic Essentials Owners Manual
19
 Series Techoo

f weather is very hot:
1. Remove spa cover
(even during the night).
Start blower if spa is
equipped with one.
Wait until spa cools
down (add cold water if
necessary).
 Shut power off and
power the spa up again
to reset the system.
3. With a voltmeter, read
voltage between the
live and ground heater
terminals.
4. If you do read 240 ,
replace spa pack.
5. If you do not read 240 ,
pump may be
overheating water
during filter cycle.
Shorten filter cycle
duration.
f hot weather is not a
factor:
2. Lower Set Point
below current water
temperature.
The Heater indicator
should disappear from
keypad display.
To shorten filter cycle
duration:
. Press and hold the Light
key for 5 seconds.
Display will show a
value that represents
the filter cycle duration
in hours.
. Use the Down arrow key
to lower the number of
hours.
0 = no filtration
12 = continuous filtration
When the desired
setting is displayed,
Press the Light key
again. The filter cycle
will start immediately.
LiveGroundReturn