Arctic Spas Y Series - Power up Breaker Setting

Arctic Essentials Owners Manual
11
 Series Techoo


Lamp test
All the segments and LEDs
light up.
Software revision Lowlevel selection
Low-level selected from
low-level menu
Software number

oot up display sequence (Each parameter is displayed for 2 seconds)
Powerup  breaker setting
MPORTAT Read before starting
Turn off the breaker.
Make sure all accessories are linked to the bonding connector and connected
to pack.
A minimum ow rate of 18 PM is required. Make sure that all valves are open in
the spa plumbing and that you have good water ow circulation from the primary
pump into the heater.
Turn on the breaker.
The values displayed by
the system correspond
to 0.8 of the maximum
amperage capacity of
the GFCI.
Use the Up/Down buttons
to select the desired value.
The value can typically be
modified from 10 to 48 A.
Press the Prog button
to set breaker rating.
This table shows typical
settings of b for different
GFCI ratings. Select the one
that matches your breaker.
FCb
0 A48 A
50 A40 A
40 A32 A
30 A24 A
20 A1 A
Note: Every OEM has its own
WYLZL[JVUÄN\YH[PVUZ

Its important to specify
the current rating of
the GFCI used to ensure
safe and efficient current
management (and reduce
nuisance GFCI trippings).
Press and hold the Prog
button until you access
the breaker setting menu
(programming menu will
HWWLHYÄYZ[
Note: if the keypad in use
does not have the Prog RL`
use the Light key instead.
in.o dryre protection
At power up, the in.flo detector performs a flow check through the following process:
Pump 1 or circulation pump starts for 2 minutes.
The display will show "  " during the check flow process. After 2 minutes the system validates proper water flow.
In case of failure, the system tries again. The water temperature is shown on the keypad display. Once the water has
reached the set point value plus 0.8F the heater is turned off.

Chose the number of
phases supplying your spa.
Use the Up/Down key to
chose the desired value
and press the Program or
light key to confirme the
selection. o u can choose
between 1, 2 or 3 phases.
umber of phase selection
ULMenu not
available
CE1, 2 or 3
UL Swim*1 or 2
CE Swim*1, 2 or 3
*See Swim Spa manual
for details.
