Ardwolf A10 - Change administrator code; Reset system

10
Menu
User Code
System
2↑,8↓, # Enter
System
Beep
About
2↑,8↓, # Enter
Admin Finger
Capacity: 5
Admin: 1
2↑, 8↓, * Exit
Menu
User Code
System
2↑,8↓, # Enter
System
User info
Admin code
2↑,8↓, # Enter
Current Code
1234_
* Exit, # Enter
Enter New Code
8888_
* Exit, # Enter
Enter again
8888_
* Exit, # Enter
Successful
Menu
User Code
System
2↑,8↓, # Enter
System
Admin code
Reset
2↑,8↓, # Enter
Reset ?
* Exit, # Enter
15. Check user information
Login system, enter menu page (refer page 5 “5. Rule of operation”).
You may check user information in the system.
16. Change administrator code
Login system, enter menu page (refer page 5 “5. Rule of operation”).
Please change default administrator code after you set up lock.
17. Reset system
Login system, enter menu page (refer page 5 “5. Rule of operation”).
You may reset system to manufacture default. All audit logs will be removed after reset but all
fingerprint and user code will remain in system. You may use delete all command to remove all
finger or user code from system.