Ardwolf A10 - Rule of operation; Enroll fingerprint

5. Rule of operation
6. Enroll fingerprint
06
Login system, enter menu page (refer page 5 “5. Rule of operation”).
User could input a desired ID
User ID: 001
Lift and reset
the finger
User ID: 001
Lift and reset
the finger again
Successful
Menu
Fingerprint
User Code
2↑,8↓, # Enter
Enroll Fingerpr.
Delete Fingerpr.
Delete All FP
2↑,8↓, # Enter
User ID
Pop up ID
Desired ID
2↑,8↓, # Enter
User ID
Pop up ID
Desired ID
2↑,8↓, # Enter
Enter user ID
(1 to 500): 1_
* Exit, # Enter
User ID: 001
Place a finger
on sensor firmly
Active lock by touching screen then touch #. Login page will show up. Login system by
Admin Code or Admin Fingerprint. After login system, following Menu to program
fingerprint, user code or set up lock.Default administrator code(1234).
Note: “2↑” stand for touching 2 to scroll cursor up. “8↓” stand for touching 8 to scroll cursor
down. “#Enter” stand for touching # to confirm.
6. Delete all fingerprint
User ID: 001
Place a finger
on sensor firmly
User ID: 001
2↑,8↓, # Enter