18
V 08/19
PRE-OPERATING CHECKS AND OPERATIONS
Before using the appliance, make sure the floater and the condensate collection tank are correctly positioned
1. Remove the tank using both hands, following the direction of the arrow.
2. Pull out the tank using both hands and verify the correct position of the floater.
3. Reposition the tank as shown in the figure below.
OPERATING INSTRUCTIONS
APPLIANCE START-UP
Place the product on a flat and stable heat-resistant surface, at least 1 metre away from flammable or heat-sensitive
materials and 50 cm away from walls or other obstructions.
Make sure the water tank is in the correct position
.
Connect the power cord to a suitable electric socket (220-240V/50Hz).
Turn the appliance on with ON/OFF on the control panel.
The unit emits a “beep” signal and the corresponding LED lights up.
The dehumidifier is designed to operate at ambient temperatures from + 5°C to + 35°C.
If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.
When this happens, the dehumidifier goes into defrost mode. The compressor stops, but the fan continues running.
The defrosting operation may start up and operate for some minutes; during the defrosting operation, the dehumidification
function may intermit: please don’t turn off the switch or pull out the power plug of the dehumidifier.
We recommend not using the dehumidifier in room temperatures lower than 5°C.
Do not remove the tank when the unit is in operation.
If you wish to make continuous draining of condensate, follow the instructions in the dedicated paragraph.
Floater
Correct
Position
Wrong
osition
To Next Page
Loading...
Need help?
General
