19
V 01/13
OPERATION WITHOUT A REMOTE CONTROL
If the remote control is not working or has been lost, the button on the control panel can be used.
1. "POWER" BUTTON
(SWITCHING ON/FUNCTION SELECTION (Cooling / Heating (NOT ACTIVE)/ Switching off)
By pressing this button consecutively on the control panel, the unit is activated, cooling mode is selected, heating mode
(NOT ACTIVE) is selected and finally the appliance is deactivated.
For Dehumidification mode, always use the remote control.
CARE AND MAINTENANCE
WARNING!
Before carrying out any cleaning or maintenance, unplug from the electric socket.
1. Cleaning the air filters.
The air filters must be checked at least once
every two weeks of use. Operating with dirty
or blocked filters will decrease the
effectiveness of the air-conditioner and can
cause serious problems.
To remove the filters, release the rear grille,
then remove the filters, pulling them
delicately upwards.
Use a vacuum cleaner to remove dust. If
this should not suffice, wash the filters with
warm water and a neutral detergent if
necessary.
Rinse with cold water and leave to air dry
before replacing. Once the two filters have
been replaced, close the grilles once again
and return to using the air-conditioner.
2. Cleaning the casing.
Use a damp and soft cloth to clean the exterior surface of the air-conditioner.
Do not use water that is too hot, solvents, petrol or other aggressive chemical compounds,
talcum powder or brushes: these may damage the surface or colour of the casing.
To remove stains use warm water with a little neutral detergent.
Do not pour water onto the air-conditioner to clean it: this may damage the internal
components or cause a short circuit.
3. Storage.
When you do not envisage using the air-conditioner for a long time, before storing it away, clean the filters.
Keep the appliance in a vertical position at all times. Do not rest heavy objects on the
top and, if possible, protect the air-conditioner with a sheet of plastic.
To Next Page
Loading...
