Argo IRO - Appliance Start-Up Procedures; Initial Setup and Component Check

V 01/19
25
The unit must be placed vertically for 2 hours before the first power on.
APPLIANCE START-UP
Open the packaging and remove the box from above. Remove the product and the other elements supplied
(illustrated in the box below).
LCD remote control
Type AAA batteries
for the remote control
(not included)
Round fitting for window (1) to be
positioned between the end of the
tube and the end fitting for the
window
Hose
End fitting for window (2)
Drainage pipe.
Window unit kit (A+B)
Window unit (A)
Cap (B)
Position the product vertically on a flat and stable surface, as close as possible to a window and at least 50 cm from walls
or other nearby obstacles.
USE WITH END FITTING FOR WINDOW
(1)