Do you have a question about the Argon 18 KRYPTON and is the answer not in the manual?
Wheel Size | 700c |
---|---|
Seatpost | Argon 18 Carbon |
Frame Material | Carbon |
Brake Type | Disc |
Drivetrain | Shimano 105 |
Shifters | Shimano 105 |
Front Derailleur | Shimano 105 |
Rear Derailleur | Shimano 105 |
Crankset | Shimano 105 |
Cassette | Shimano 105 |
Chain | Shimano |
Brakes | Shimano 105 hydraulic disc |
Wheels | Vision Team 30 |
Check specific parts on the frame like seatpost, derailleur hangers, and bottle cage for correct assembly and torque.
Install the 3D headset according to the pressfit assembly guide, choosing from 25mm, 15mm, or 0mm height options.
Install front and rear derailleur and brake cables, measuring sufficient housing length for proper handlebar movement.
Route rear brake cable housing, removing stoppers and correctly measuring for clearance.
Route front and rear derailleur cables through the frame and into the bottom bracket cable guide.
Use a brake cable and metal cable end for easier Di2 cable routing.
Utilize appropriate downtube grommets for mechanical or electronic drive-train cable fixing.
Use the correct grommet/stopper for the rear derailleur, noting Di2 configuration requirements.
Use cable guide pipe for mechanical or grommet for electronic front derailleur cable routing.
Install the Di2 battery securely in the seatpost using the battery holder and a slight amount of grease.
Install the saddle on the rocker and tighten the rail clamp using the screw and specified torque.
Flip the rocker and rail clamp to adjust the saddle offset by 5mm.
Adjust the front derailleur hanger for optimal curve alignment with the big chainring using Loctite.
Lists and identifies main frameset parts including the frame and fork.
Details components for the seatpost assembly, such as the rocker and rail clamp.
Lists parts installed on the frame, including derailleur hangers and cable guides.
Identifies specific parts required for Di2 electronic drive-train configurations.