argon audio IE20 User Manual

w w w . a r g o n a u d i o . c o m
IE20 Quick start
1. Charging instruction
Please fully charge the case and ear buds before first
time use. The different numbers of LEDs on the
bottom of the charging case flashing will show the
different charge level of the case; see the chart below
for details. When the charging case is fully charged,
all four lights turn on.
Power
LED light
<25%
The rst light is ashing
25-50%
The rst light is on, and the second light is blinking
50-75%
The rst two light is on, and the third light is blinking
75-99%
The rst three lights are on, the 4th light is blinking
100%
All four lights are on
2. Power on/pairing mode
Open the charging case while the earbuds are still in
the case to initiate pairing mode. Enter Bluetooth
settings on your device and select Argon Audio IE20
to start pairing. If the pairing was successful; you will
hear the "connected" voice prompt in the ear buds.
To enter pairing mode manually, place both left and
right earbuds into the charging case, keeping the
case cover open. Press and hold the charging case
button for 5 seconds. The four LEDs will flash
alternately in pairs before emitting constant light for
3 seconds. This indicates that the earphones have
entered Bluetooth searching and pairing mode. If
there is no connection in pairing mode for 5 minutes,
the earbuds will automatically power off.

argon audio IE20 Specifications

General

Brand	argon audio
Model	IE20
Category	Speakers
Language	English