Need help?Do you have a question about the Argox AS-8000 Series and is the answer not in the manual?
General| Brand | Argox |
|---|---|
| Model | AS-8000 Series |
| Category | Barcode Reader |
| Language | English |
Steps for configuring scanner settings for optimal performance.
Steps for connecting the scanner using a keyboard wedge interface.
Steps for connecting the scanner using an RS-232 interface.
Steps for connecting the scanner using a USB interface.
Describes methods for programming the scanner via barcodes or commands.
Details on upgrading the scanner's firmware using flash memory.
Lists various configurable features and settings of the scanner.
How to select and configure the scanner's interface (Keyboard, RS232, USB).
Feature for automatic detection of keyboard, RS232, or USB interfaces.
How to select the appropriate keyboard connector type for the host.
Setting the keyboard layout for different country languages.
Adjusting scanner output speed to match host computer.
Configuring function keys and enabling numeric keypad output.
Setting Caps Lock status and simulating keyboard for PC power-on.
Inserting delays between characters and data outputs.
Configuring communication protocols (None, RTS/CTS, Xon/Xoff, ACK/NAK).
Inter-character, block transmission, and response delay settings.
Configuring serial communication parameters like speed and bits.
Setting signal polarity for wand emulation and initial state.
Configuring speed, margin, and transmission delays for wand emulation.
Pinout details for 8-pin and 10-pin RJ-45 connectors.
Pinout for Keyboard Wedge (Mini-DIN, DIN) and RS-232 (DB-9F).
Pinout for Keyboard Wedge PS/2 connectors (Mini-DIN 6P).
Defines trigger operation modes (Momentary, Alternate, etc.).
Sets confirmation requirements for successful barcode reads.
Improves reliability for barcodes with extensions.
Defines minimum and maximum readable code lengths for all symbologies.
Enables inverted barcode scanning and external trigger control.
Reduces power consumption by entering idle status with reduced illumination.
Scan beam aiming aid and control for scanner idle status.
Improves reading performance for low PCS value barcodes.
Scanner alert signals for self-test and LED indicators for reads.
Adjusts beep volume, frequency, and duration for read confirmation.
Settings for UPCA read, checksum, truncation, and code ID.
Settings for UPCE read, checksum, truncation, expansion, and supplement digits.
Settings for EAN-13 read, checksum, truncation, and ID/supplement digits.
Settings for EAN-8 read, checksum, truncation, and ID/supplement digits.
Settings for Code 39 verification, transmission, length, truncation, and ID.
Settings for Interleaved 2 of 5 checksum verification and transmission.
Settings for Codabar checksum, start/end transmission, and group selection.
Settings for Code-128 checksum and format (UCC/EAN-128).
Settings for Code-93 verification, transmission, length, and truncation.
Checksum verification and transmission settings for MSI/plessey and UK/plessey.
Checksum verification and transmission settings for Telepen and Standard 2 of 5.
Length and leading character settings for China Post and Italian Pharmacode.
Truncation, ID setting, and length for Code-16K and PDF-417.
Truncation, ID setting, and UCC/EAN 128 emulation for RSS-14, Limited, Expanded.
Truncation and ID setting for Micro-PDF barcodes.
Setting prefix or suffix characters for data transmission.
Appends preamble or postamble characters before/after transmitted data.
Defines characters for groups and their insertion position in symbologies.
Code ID position, name, length transmission, and case conversion.
Samples of enabled bar codes for testing purposes.
Displays the current configuration of the scanner.
Displays the unique parameter setting list.
Displays product information and revision number.
Displays the string format list.
Displays the current scanner firmware version.
Resets the scanner to its factory default settings.
To Next Page
