Why am I getting a Serial IO error on my Argox Barcode Reader?
If you're encountering a Serial IO error with your Argox Barcode Reader, examine the baud rate, format, or protocol settings to ensure they match between the host device and the printer.
How to fix a miss-detected gap on Argox X-3200ZE?
If your Argox Barcode Reader is miss-detecting the gap, check the media path and the position of the label sensor.
What to do if the cutter failed on my Argox Barcode Reader?
If the cutter has failed on your Argox Barcode Reader, check the media and the connection between the cutter and the main board.
Instructions for properly connecting the printer's power cord.
Steps for loading media in standard mode.
Steps for loading media in peel-off mode.
Steps for loading media in cutter mode.
Procedure to adjust the label sensor for accurate detection.
How to modify printer settings using the front panel buttons.
Procedure for calibrating the label sensor for optimal performance.
General| Model | X-3200ZE |
|---|---|
| Interface | USB, RS-232 |
| Scan Rate | N/A (Printer, not a scanner) |
| Resolution | 203 dpi |
| Barcode Types | PDF-417, QR code, Data Matrix |
| Operating Temperature | 5°C to 40°C |
| Electrical Specifications | 100-240VAC, 50-60Hz |
| Humidity | 5% to 95% (non-condensing) |
To Next Page
