To Next Page
A
Andrea RodriguezAug 10, 2025
What to do if media is not installed in Argox G6000?
- JjamesmicheleAug 10, 2025
If the media is not installed in your Argox Barcode Reader, install the media roll.
What to do if media is not installed in Argox G6000?
If the media is not installed in your Argox Barcode Reader, install the media roll.
What to do if there is a ribbon jam in Argox Barcode Reader?
If there is a ribbon jam in your Argox Barcode Reader, recover the jam.
What to do if there is a media jam in Argox Barcode Reader?
If there is a media jam in your Argox Barcode Reader, recover the jam.
Why does my Argox G6000 show a SERIAL IO ERROR?
A SERIAL IO ERROR on your Argox Barcode Reader typically occurs due to an inconsistent baud rate, format, or protocol between the host and the printer. To resolve this, check bits 6 through 8 of the DIP switch, referring to section 2 for DIP switch details.
What to do if the ribbon has run out on Argox G6000?
If the ribbon has run out on your Argox Barcode Reader, you should supply the ribbon roll.
Considerations for printer placement and environment setup.
Steps for correctly connecting the printer's power supply.
Overview of the printer's front panel components and indicators.
Explanation of the READY, MEDIA, and RIBBON LED statuses.
Details on the functions of the FEED, PAUSE, and CANCEL buttons.
Description of messages and status shown on the LCD screen.
Steps to perform a self test and print a configuration report.
Instructions for connecting the printer to a PC via parallel or serial ports.
Essential safety guidelines for operating and maintaining the equipment.
General| Print Method | Thermal transfer and direct thermal |
|---|---|
| Resolution | 203 dpi |
| Print Width | 4.09 inches |
| Memory | 8MB Flash |
| Processor | 32-bit RISC |
| Interfaces | USB, Serial |
| Sensors | Reflective sensor, Transmissive sensor |
| Power | 100-240V AC, 50/60Hz |
