e2v technologies (uk) limited 2013 CR 114528 05 Apr 2013 DAS775571AA Version 1, page 9
3.7 Getting Started
The packing case contains the following items (see Quick Start Guide):
• Camera with lanyard loops
• Charger Station
• Quick Start Guide
• Two rechargeable battery packs
• USB Lead
• Retractable lanyard
• Power Supply Kit:
• Mains power supply
• Set of interchangeable plugs
• Vehicle power lead (12 V)
• Pocket Clip
• Picatinny rail accessory with 2 mounting screws
• Universal Mounting Plate for Charger with 2 mounting screws
• 3 mm hex key
• 2.5 mm hex key
Basic Operation
• Turn the camera on with a short press of the green button.
• After about one second a start-up image will appear on the screen. (This
image may be changed – see section 4.5). After a few more seconds the
display will show the thermal image.
• The time and date will be displayed for a further 5 seconds.
• While the camera is in operation, it will recalibrate to maintain its
performance and image quality. During recalibration, an internal shutter
closes and the image will briefly freeze while the internal electronics
optimises the performance of the sensor. This occurs more frequently
when first turned on, then the calibration interval increases as the internal
temperature of the camera stabilises.
• To turn the camera off, press and hold the green button for two seconds
until the camera turns off.
To Next Page
Loading...
