Ariens 920014 Quick Start Guide

30 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Quick Start Guide

Compact 24 LE (920014 s/n 100000 & up)

• Step 1: Assemble Handlebar

• Step 2: Install Discharge Chute

• Step 3: Install Discharge Chute Crank

• Step 4: Install Remote Deflector Cable

• Step 5: Check Function of Dual Handle Interlock

• Step 6: Check Tire Pressure

• Step 7: Adjust Skid Shoes

• Step 8: Check Auger Gearcase Oil

• Step 9: Check Engine Crankcase Oil

• Step 10: Fill Engine Fuel Tank

• Step 11: Starting the Engine

• Step 12: Stopping the Engine

READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.

IMPORTANT: READ OPERATOR’S MANUAL AND ENGINE MANUAL

THOROUGHLY AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES

BEFORE OPERATING.

Table of Contents

Other manuals for Ariens 920014

Owner's/Operator's Manual42 pages

Service Campaign8 pages

Questions and Answers:

J
Jeffrey HunterAug 12, 2025
Why won't my Ariens 920014 Snow Blower engine crank or start?
- V
  vbakerAug 12, 2025
  Your Ariens Snow Blower might not crank or start due to several reasons: * The fuel tank could be empty, in which case you should fill it. * The fuel shut-off valve might be closed; open it. * There might be a buildup of dirt and residue around the governor/carburetor; clean this area. * The key switch may not be in the run position; put it in the run position. * The electric starter could be malfunctioning; check the starter and its connections.
K
Kimberly AndrewsAug 16, 2025
Why is my Ariens 920014 Snow Blower not throwing snow?
- T
  Terry WestAug 16, 2025
  If your Ariens Snow Blower isn't throwing snow, here's what might be happening: * The shear bolts may be broken; replace them. * The attachment clutch/brake might not be adjusted properly; adjust it. * The auger could be frozen in place; move the unit to a warm place to thaw it. * Ice or debris might be obstructing the auger; with the engine off and auger disengaged, check for and remove any obstructions. * The attachment drive belt might be slipping, worn, or damaged; adjust or replace it.
F
Frances JacobsAug 19, 2025
Why won't my Ariens Snow Blower engine start?
- M
  Mathew GoodmanAug 19, 2025
  Your Ariens Snow Blower engine might not start due to several reasons. The fuel tank could be empty, so fill it up. The fuel shut-off valve might be closed, so open it. There might be dirt and residue around the governor/carburetor, so clean the area. The key switch might not be in the run position, so put it in the run position. Finally, the electric starter might not be functioning, so check for a bad starter or connections.
R
rachelgomezAug 23, 2025
Why does my Ariens 920014 Snow Blower not throw snow properly?
- C
  craig42Aug 23, 2025
  If your Ariens Snow Blower isn't throwing snow well, check a few things. First, shear bolts might be broken. Also, the auger might be frozen in place, so move the unit to a warm place to thaw it. Ice or debris might be obstructing the auger; with the engine off and auger disengaged, check for obstructions and remove them. Another cause can be that the attachment drive belt is slipping, worn, or damaged.
M
Michele HawkinsAug 27, 2025
What causes small rubber beads to collect in the frame of my Ariens Snow Blower?
- T
  tthorntonAug 27, 2025
  Small rubber beads collecting in the frame of your Ariens Snow Blower are typically due to normal friction disc wear. If you notice chunks or large pieces of rubber, it indicates that the friction disc should be checked and replaced if necessary.
C
chelseajonesAug 31, 2025
What to do if my Ariens 920014 engine stops?
- G
  Gina RubioAug 31, 2025
  If your Ariens Snow Blower engine stops, consider the following: * Check if you're out of fuel and fill the tank if needed. * Ensure the fuel shut-off valve is open. * Look for any mechanical jams in the blower rake or impeller. If there's an obstruction, turn off the engine, remove the key, wait for all moving parts to stop, and then remove the obstruction before restarting. * The fuel supply might be polluted; replace it with clean fuel. * The spark plug could be faulty; replace or clean it. * The fuel cap vent might be plugged; replace the fuel cap.
P
pparkerSep 3, 2025
Why won't my Ariens 920014 Snow Blower operate in forward or reverse?
- S
  snydersueSep 3, 2025
  Your Ariens Snow Blower may not operate in forward or reverse due to: * A worn-out friction disc; replace it. * A malfunctioning traction belt; repair or replace it. * A speed selector that isn't adjusted properly; adjust it.
D
Deanna MilesSep 7, 2025
Why are there small rubber beads collecting in the frame of my Ariens Snow Blower?
- M
  Michelle BaileySep 7, 2025
  The small rubber beads collecting in the frame of your Ariens Snow Blower are likely due to normal friction disc wear. However, if you notice chunks or large pieces of rubber, the friction disc should be checked and replaced if necessary.

Ariens 920014 Specifications

General

Type	Two-stage
Engine	Ariens AX
Engine Type	4-cycle
Engine Displacement	208cc
Clearing Width	24 in
Intake Height (in)	21
Drive System	Disc-O-Matic
Forward Speeds	6
Reverse Speeds	2
Chute Rotation	Manual
Electric Start	Yes
Clearing Height	21 inches
Auger Type	Serrated Steel
Tire Size (in)	13
Engine Displacement (cc)	208 cc

Related product manuals

Preview: Ariens 920013

Preview: Ariens 920014 COMPACT 24 LE

Ariens 920014 COMPACT 24 LE

Preview: Ariens 920006

Preview: Ariens 920021-Compact 24 LE

Ariens 920021-Compact 24 LE

Preview: Sno-Thro 920021 compact 24

Sno-Thro 920021 compact 24

Ariens Sno-Thro 920 Series