EN - 27
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Engine will not
start
1. Fuel tank empty or low.
2. Spark plug wire loose or off.
3. Operator presence control
cable detached, broken, or not
adjusted properly.
1. Check fuel level. Fill tank if
necessary.
2. Check connection.
3. Check cable. Adjust, repair
or replace as necessary.
Engine is
difficult to
restart
1. Mower clogged with grass. 1. Clear clippings from under
mower. (Allow the mower to
clear clippings before
shutting off engine.)
Poor cut
quality
1. Worn blade.
2. Too much grass is being
removed per cutting.
3. Grass is too wet.
4. Mowing speed is too fast.
1. Check blade (see CHECK
MOWER BLADE on
page 19).
2. Raise cutting height.
3. Allow grass to dry.
4. Mow slower.
Grass does
not disperse
evenly
1. Too much grass is being
removed per cutting.
2. Grass is too wet.
3. Mowing speed is too fast.
1. Raise cutting height.
2. Allow grass to dry.
3. Mow slower.
Mower does
not bag
clippings
1. Grass bag is overfilled.
2. Mulching plug is installed.
1. Empty grass bag and do not
allow it to overfill.
2. Remove mulching plug.
Wheel drive
does not
engage (Self-
Propelled
models)
1. Wheel drive control not
engaged.
2. Drive belt out of position.
3. Drive belt worn or damaged.
4. Wheel drive control cable
detached or broken.
5. Bearings damaged.
6. Debris in gear set.
7. Drive slips or speed is too
slow.
1. Engage wheel drive control.
2. Check drive belt. Adjust as
necessary (see CHECK
DRIVE BELT on page 21).
3. Replace belt (see CHECK
DRIVE BELT on page 21).
4. Check wheel drive control
cable. Adjust or replace as
needed. See CHECK
WHEEL DRIVE CONTROL
on page 19.
5. Contact your Dealer.
6. Contact your Dealer.
7. See ADJUST WHEEL
DRIVE CONTROL on
page 25.
To Next Page
Loading...
Need help?
General
