Aries Portable Spa - Spa Operation; Initial Start-up and Filling

Page 3
Aries Spas • User Manual
waterwillnothitthesidingofthespa.
Gatesgivingaccesstothespashouldbeself-closingandself-lockingfor
safety.
Operation
Initial Start-up
Please read this section fully before attempting initial start-up of
your spa.
Always turn the thermostat(s) and electric power off when lling or
draining the spa, and always fully open any valves that could restrict
water ow to and from the heater element.
Filling your Spa
Yourspashouldbelledwithwatertoapproximatelythemiddleofthe
skimmer(toidentify,seepictureofskimmerinthe“SuctionsFittings”
sectionofthismanual).Thewaterlevelshouldneverbebelowtheregu-
larorwhirlingjets,butshouldnevercoveranyneckjets,therecoveryjet
(see“Jets”sectionforpicture)orbuilt-inpillows.Do not overll spa.
Starting your Circulating Pump
Turnonyourhomecircuitbreakerandservicedisconnect(ifapplicable).
Pushthered“reset”buttonontheGFCI,locatedontherightsideofthe
blackequipmentbox.Within5seconds,thepurgecyclewillcomeon,
runningthejetsandblowerfor
30seconds.Thenthecirculation
pumpwillcomeon.If,withina
fewseconds,waterisnotobserved
owingfromReturnJets(see“Jets”
sectionfordescription),liftthelid
thatcoversyourTopLoadingPres-
sureFilter,andreleaseanytrapped
Equipment Pack