EasyManua.ls Logo

Aries Portable Spa - Troubleshooting Guide; Spa Equipment Not Operating

Default Icon
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 26
Aries Spas • User Manual
Note: The above method of starting a siphon only works
when the faucet is below the water level of the spa.
Anotherwayofemptyingyourspaistousethefaucetorspigotthatis
builtintoyourAriesSpa,attachedtotheequipmentpack.Openthevalve
(turnthespigot).Itisbestifyouattachagardenhosetothefaucet,keep-
ingthewateroffoftheEquipmentPack.Thewaterwillstarttodrainout
aslongasthefreeendofthehoseisbelowthewaterlevelofthespa.
Note: The above method will drain the water only to the
level of the lowest circulating tting in the spa (the lowest
Bottom Suction). The remaining water will have to be siphoned
(as described above) or bailed out.
Troubleshooting Guide
Problem Possible Causes/Solutions
Spa Equipment does not operate. Nothing works.
GFCI has possibly tripped or may be turned off.
ResetGFCIonspapackbypushing“On”.IfGFCIresetsforamo-
ment,thentripsagain,see“Blowerdoesnotwork”below.
Household circuit breaker has tripped.
Switchbreakerto“Off”position,thenresetto“On”.
Equipment is not wired correctly, or isn't provided with
proper power.
Ifyouhavequestionsaboutwhetheryourspaiswiredcorrectly,call
yourspadealerorthefactory.
Fuse has blown
Checktoseeiffusehasblown.FuseislocatedabovetheGFCIon
therightsideoftheequipmentpack.Iffuseisblown,itcanonlybe
replacedwithAGC1/2,250volt,quick-blow(glass)fuse,availableat
Aries'Store,somehardwarestores,RadioShack,etc.