OPERATING FROM THE REMOTE CONTROL (cont.)
Fan mode(Not Fan speed button)
Air ventilation only.
●To set the Fan mode, press “Mode button” until the symbol
“Fan mode” appears in the display.
●Press the “Fan speed button” to select the fan speed:Low,Medium,
High or Auto.
NOTE:
●When using the appliance in this mode, the air hose does not
need to be attached.
Heating mode
The heating function allows the air conditioner to heat the room.
●Only the heat pump model have this function.
If the appliance is only cooling model, when choose the heat mode,
appliance will turn to Fan mode.
To set this mode correctly:
●To activate the heating function ( HEAT) ,press the “Mode button”
until the symbol “Heating mode” appears on the display.
●With the button “Increase button” or “Decrease button” set a
temperature 13℃-27℃(55℉-81℉) higher than that of the room.
●Press the “Fan speed button” to select the fan speed:Low,Medium,
High or Auto.
NOTE:
●At the beginning of this mode,you may have to wait a few seconds before
The appliance starts to give out hot air
●In HEATING operation, the appliance can automatically activate a defrost
cycle, which is essential to clean the frost on the condenser so as to recover
its heat exchange function. This procedure usually lasts for 2-10 minutes.
During defrosting, the unit fan stop operation. After defrosting, it resumes to
HEATING mode automatically.
-In this mode, you may have to wait for a few minutes before the appliance
starts giving out hot air.
-In this mode, the fan may operate for short periods, even though the
set temperature has already been reached.
●Water is removed from the air and collected in the tank.
●When the tank is full, the appliance shuts down and “FT”(full tank)
appears on the display. The tank cap must be extracted and emptied.
Run off all water left into a basin. When all the water has been drained,
put the cap back in place.
●When the tank has been emptied, the appliance starts up again.
To Next Page
Loading...