Ariston AURES MULTI User Manual

8
EN
Troubleshooting
SYMPTOM POSSIBLE CAUSE SOLUTION
Water not hot
enough
Too much water owing through
the heater
Reduction In the ambient
temperature
Water Pressure below of 100 kPa
Electrical Malfunction
Reduce the ow rate of the water via the
outlet tap.
Switch to higher temperature setting.
Check if the mains stop valve is fully open
and that the there are no other restriction
in the supply line.
Have the Heater unit checked by a
qualied eIectrician or contact your local
authorised distributor.
Water too hot Not enough Water owing through
the heater
Increase in the ambient temperature
Increase the ow rate via the outlet tap
Switch to lower temperature setting
Heater switch O
during use
Interruption of mains electrical
supply
ELSD trip, possible earth leakage
Check incoming power supply, MCB,
switches and supply cabling. Check earth
leakage and reset ELSD
If problem persists, call your local
authorised distributor for assistance.
Water ceases to
ow
Blockage of spray head, twisted or
blocked exible shower hose.
No water supply.
Clean or replace spray head, check for
free passage of water through hose.
Replace as necessary.
Check water supply, stop valve Open?
and no blockage.
Water
temperature
varies from hot to
cold during use
Water pressure has dropped below
min. level.
Increase hot water supply,
No hot water
despite fully open
hot water outlet
No electrical power
The activation ow rate needed to
turn on the heating element has not
been reached.
Check the circuit breaker and check
voltage at the wiring block.
Clean lter screen
• Turn circuit breaker o
• Open hot valve to release pressure from
the unit.
• Turn circuit breaker on.

Ariston AURES MULTI Specifications

General

Brand	Ariston
Model	AURES MULTI
Category	Water Heater
Language	English