4
overview
Advice for the installer
The installation and rst ignition of the
boiler must be performed by qualied personnel
in compliance with current national regulations
regarding installation, and in conformity with
any requirements established by local authorities
and public health organisations.
After the boiler has been installed, the installer
must ensure that the end user receives the
declaration of conformity and the operating
manual, and should provide all necessary
information as to how the boiler and the safety
devices should be handled.
These appliance are designed for use on open
vented central heating systems. A kit is available to
allow the boiler to be used on a sealed system. These
appliances are designed for domestic use only.
It should be connected to a heating system and a
distribution network for domestic hot water, both of
which must be compatible with its performance and
power levels.
The use of the appliance for purposes other than
those specied is strictly forbidden. The manufacturer
cannot be held responsible for any damage caused
by improper, incorrect and unreasonable use of
the appliance or by the failure to comply with the
instructions given in this manual.
Installation, maintenance and all other interventions
must be carried out in full conformity with the
governing legal regulations and the instructions
provided by the manufacturer. Incorrect installation
can harm persons, animals and possessions;
the manufacturing company shall not be held
responsible for any damage caused as a result.
The boiler is delivered in a carton. Once you have
removed all the packaging, make sure the appliance
is intact and that no parts are missing. If this is not
the case, please contact your supplier.
Keep all packaging material (clips, plastic bags,
polystyrene foam, etc.) out of reach of children as it may
present a potential hazard.
In the event of a fault and/or malfunction, turn
the appliance o, turn o the gas cock and do not
attempt to repair it yourself. Contact a qualied
professional instead.
Before any maintenance or repair work is performed
on the boiler, make sure you have disconnected it
from the electricity supply by switching the external
bipolar switch to the “OFF” position and removing
the fuse.
All repairs, which should only be performed using
original spare parts, should be carried out by a
qualied professional. Failure to comply with the
above instructions could compromise the safety of
the appliance and invalidate all liability on the part
of the manufacturer.
In the event of any maintenance or other structural
work in the immediate vicinity of the ue or ue
gas exhaust devices and their accessories, switch
the appliance o by switching the external bipolar
switch to the “OFF” position and shutting o the gas
control valve. When the work has been completed, a
qualied technician must check the eciency of the
ue and the devices.
Turn the boiler o and turn the external switch “OFF”
to clean the exterior parts of the appliance.
Clean using a cloth dampened with soapy water. Do
not use aggressive detergents, insecticides or toxic
products. If the appliance is used in full compliance
with current legislation, it will operate in a safe,
environmentally-friendly and cost-ecient manner.
If using kits or optional extras, make sure they are
authentic.
CE labelling
The CE mark guarantees that the appliance conforms
to the following directives:
-
90/396/CEE
relating to gas appliances
-
2004/108/CEE
relating to electromagnetic compatibility
-
92/42/CEE
relating to energy eciency
-
2006/95/CEE
relating to electrical safety
Symbols used on the data plate
To Next Page
Loading...
Need help?
General