Ariston FAST R X ONM 11 - Commissioning Procedures

/ 17
COMMISSIONING
WARNING!!
DO NOT USE THE APPLIANCE WITHOUT
WATER.
Initial procedures
To guarantee safety and the correct operation of the
appliance,theappliancemustbepreparedforoperation
byaqualiedtechnicianwhopossessestheskillswhich
arerequiredbylaw.
It’s necessary check the gas adjustments when you
start the appliance for the rst time.
Electricity supply
-Insert the batteries into the relevant compartment
correctlybasedontheirpolarities.
Filling the hydraulic circuit
Proceedinthefollowingmanner:
-Graduallyopenthevalvelocatedonthecoldinlet;
-openaD.H.W.tap.
Gas supply
Proceedinthefollowingmanner:
- Makesurethat themain gassupplyuses thesame
typeofgasasindicatedontheappliancedataplate;
- Openalldoorsandwindows;
- Makesuretherearenosparksornakedamesinthe
room;
- Make surethatthe system doesnotleak fuel using
acut-offvalveinsidetheapplianceitselfwhichshould
be closed and then opened while the gas valve is
disabled.Themetermustnotshowanysignsofgas
beingusedfor10minutes.
WARNING!!
Water with a temperature higher than
50°C can cause serious burns.
Always verify water temperature before
use.
WARNING!!
DO NOT USE THE APPLIANCE WITHOUT
WATER.
First ignition
The rst start-up must be carried out by a QUALIFIED
TECHNICIAN.
Makesurethat:
- Thegasvalveisclosed;
- theexhaustductfor combustionproducts shouldbe
suitableandfreefromanyobstructions;
- ANY NECESSARY VENTILATION INLETS IN THE
ROOM SHOULD BE OPEN (TYPE B INSTALLATION).
Turn the knob between the positions of minimum and
maximum.
StarttheappliancebyopeningaD.H.W.tap.