10
GB
Maintenance and care
Switching the appliance off
Disconnect your appliance from the electricity supply
before carrying out any work on it.
Cleaning the appliance
The stainless-steel or enamel-coated external parts as
well as the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water and
neutral soap. If these stains are difficult to remove, use
only specialised products. After cleaning, rinse and
dry thoroughly. Do not use abrasive powders or
corrosive substances.
Ideally, the inside of the oven should be cleaned after
each use, when it is still lukewarm. Use hot water and
detergent, rinse and dry with a soft cloth. Do not use
abrasive products.
The accessories can be washed like everyday
crockery (even in your dishwasher).
Never use steam cleaners or pressure cleaners on the
appliance.
Cleaning the oven door
Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry thoroughly
with a soft cloth. Do not use rough abrasive material or
sharp metal scrapers as these could scratch the surface
and cause the glass to crack.
To clean more thoroughly, you can remove the oven door.
1. Open the oven door fully (see
diagram)
2. Lift up and turn the small
levers located on the two hinges
(see diagram)
3. Grip the door on the two
external sides and close it
approximately half way.
Pull the door towards you lifting it
out of its seat (see diagram).
To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven periodically. If the
seals are damaged, please contact your nearest After-
sales Service Centre (see Assistance). We recommend
not using the oven until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar one:
Wattage 25 W, cap E 14.
3. Replace the glass cover (see diagram).
To Next Page
Loading...
