Ariston FZ 990 C.1 - Assembling the Sliding Rack Kit

23
GB
Assembling the sliding rack kit
To assemble the sliding racks:
1. Remove the two
frames, lifting them
away from the spacers
A (see figure).
2. Choose which shelf
to use with the sliding
rack. Paying attention
to the direction in which
the sliding rack is to be
extracted, position joint
B and then joint C on
the frame.
3. Secure the two
frames with the guide
rails using the holes
provided on the oven
walls (see diagram).
The holes for the left
frame are situated at
the top, while the holes
for the right frame are
at the bottom.
4. Finally, fit the frames on the spacers A.
 Do not place the sliding racks in position 5.
D
A
B
C
Left
guide rail
Right guide
rail
Direction
of extraction