Merloni Elettrodomestici
Instruction Manual Language Edition Page
Side-By-Side Refrigerator – Ariston MSZ 70 NF EN 2004.11.11 70 - 88
3.2.1. R
EMOVING THE ICE MAKER WATER FILLER PIPE
• The pipe in question is made of metal and clad with a heating element to prevent the water contents
from freezing.
• The pipe is inclined downwards from the internal side to facilitate the flow of water.
• At the top right of the rear of the fridge remove the 2 screws securing the union of the white water
filler pipe; remove the white plastic restraint and pull the grey union outwards by a few centimetres.
3.2.2. F
ROM INSIDE THE FREEZER
:
• Remove the ice tray
• Detach the connector located behind the ice maker and above the filler pipe
• Completely extract the pipe from the rear of the fridge.
• Refit the pipe by performing the operations in reverse sequence
- Impedance test: approximately 9700 Ohm
- Inspection of pipe: visual, ensure pipe is not clogged
- Check that grey union (seal) is watertight and shows no signs of leaks
3.2.3. R
EMOVING
/
REFITTING THE WATER TANK
• Remove the upper salad crisper drawer and its cover
• Remove the tank fixing screw
• Expose the filler and drain pipes by peeling back the thermal insulation
• Unscrew the Teflon unions and withdraw the pipes
• Refit the parts by performing the steps in reverse sequence and ensuring the pipes are inserted in
their Teflon unions and then completely tightened
• Check that the pipes are not crushed or kinked
• Check the connections for possible signs of leaks
• Remember to refit the guides for bends in the pipe to prevent possible kinks from forming for the
BLUE pipe = water inlet to tank
• WHITE pipe = water to front union and to dispenser
To Next Page
Loading...
