Aritech 2X-A Series Installation Manual

Chapter 3: Configuration and commissioning
62 2X-A Series Installation Manual
Activating service mode
Select Activate service mode to avoid accidental activation or deactivation of
outputs or output groups (local or remote) during tests.
In this mode the control panel indicates and logs activation events as configured
but does not activate or deactivate the corresponding output. This can be used to
verify control panel event configuration and to verify that outputs are not
activated accidentally.
To activate service mode:
1. Select Test from the Main menu, and then select Service mode.
2. Select Activate service mode, and then select YES (to activate service mode)
or NO (to deactivate service mode).
3. Select Global, and then select YES (to activate service mode across the
network) or NO (for local testing only).
4. Press F2 (Exit) to exit the menu.
Remember to exit service mode when all tests are completed.

Aritech 2X-A Series Specifications

General

Brand	Aritech
Model	2X-A Series
Category	Smoke Alarm
Language	English