Aritech 2X-A Series - Load Auxiliary Files

Chapter 3: Configuration and commissioning
2X-A Series Installation Manual 87
Load auxiliary files
Select Load auxiliary files to load auxiliary files from a USB flash drive. Auxiliary
files that can be loaded include custom standby and alarm screens, and updated
language or font files provided by the manufacturer.
Note: Use only FAT32 file system USB flash drives with a maximum capacity of
32 GB.
Adding custom standby and alarm screens
Select Splash screens to add custom standby and alarm screens in binary (BIN)
format.
To prepare custom screen images:
1. Convert the graphics file to BIN format using a graphics file converter or the
Configuration Utility.
2. Save the converted file as logo1.bin at the path “\_Panels\xxx\bitmap\” on a
USB flash drive.
Only the xxx in the above folder path can be changed.
To add custom screen images:
1. Open the control panel door and insert the USB flash drive into either of the
USB type A connectors (see “Cabinet and PCB layout” on page 19). Close
the control panel door.
2. Select Panel setup from the Main menu.
3. Select Configuration, and then select Load auxiliary files.
4. Select Splash screens.
5. Select the logo1.bin file to load and confirm the selection.
6. Press F4 (Enter), and then press F1 (Back).
7. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
8. Remove the USB flash drive as described in “Removing a USB device” on
page 57.