Aritech 2X-A Series - Page 84

Chapter 3: Configuration and commissioning
78 2X-A Series Installation Manual
SNTP server
Select SNTP server to configure the Simple Network Time Protocol (SNTP)
server settings. SNTP is a networking protocol for clock synchronization.
Note: Polling settings for the SNTP server must be enabled separately – see
“Auto date and time” on page 96.
To configure the SNTP server:
1. Select Panel setup from the Main menu, and then select Communications.
2. Select SNTP server.
3. Enter the IP address of the SNTP server.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.