What to do if the Arkray AUTION ELEVEN AE-4022 waste box is full?
If the test strip waste counter exceeds 90 at the end of a measurement, cancel the error notice by pressing the designated button. Then, empty the used test strips from the waste box and press the button again.
What to do if Arkray AUTION ELEVEN AE-4022 Measuring Instruments show 'Transport error'?
If a transport error occurs, it might mean the test strip wasn't moved properly. Try these steps: first, clean the test strip tray and suction ports. Next, make sure the suction ports are correctly attached. Finally, clean the incoming strip sensor window.
What to do if Arkray AUTION ELEVEN AE-4022 Measuring Instruments show 'No dipping'?
If you receive a 'No dipping' error, it means the entire pad section of the test strip wasn't dipped properly. Dip a new test strip in the sample correctly and test again.
What to do if Arkray Measuring Instruments show 'Power down'?
If the instrument was suddenly turned OFF during measurement, retest the sample(s) currently being measured.
What to do if Arkray AUTION ELEVEN AE-4022 show 'Surplus urine is full'?
If the total number of measurements since turning ON the instrument exceeded 190, turn OFF the instrument and discard any surplus urine.
What to do if Arkray Measuring Instruments show 'Data not found'?
If no data was found in the specified range, verify that the specified range for re-printing, re-sending, or list printing is appropriate.
What to do if Arkray Measuring Instruments show 'Wrong test strip'?
If the wrong test strip was used, only use ARKRAY’s test strips designed for the AUTION ELEVEN.
What to do if Arkray Measuring Instruments show 'Incorrect test strip position'?
If the test strip was displaced from its correct position due to vibration, do not expose the instrument to any vibration during measurement. If the test strips were incorrectly placed, place the test strips correctly on the test strip tray.
What to do if Arkray AUTION ELEVEN AE-4022 Measuring Instruments show 'Abnormally high reflectance'?
If an abnormal sample (e.g. a sample containing medicine) was measured, check if the tested sample is abnormal or not. If the sample is normal, test it again.
Why does my Arkray AUTION ELEVEN AE-4022 Measuring Instruments show 'Drift'?
The 'Drift' error appears when the ambient light level around the instrument changed rapidly, due to a photoflash or other reasons. To fix this, maintain a constant level of illumination around the instrument during measurement.
General| Sample Type | Urine |
|---|---|
| Power Supply | AC100-240V, 50/60Hz |
| Sample Loading | Automatic |
| Display | LCD screen |
| Connectivity | USB, RS-232 |
| Weight | Approx. 60 kg |
| Measurement Method | Reflectance Photometry |
| Measurement Items | pH, ORP, Conductivity, Temperature |
To Next Page
