To Next PageTo Next Page
Need help?Do you have a question about the Armstrong HEP OPTIMO and is the answer not in the manual?
General| Model | HEP OPTIMO |
|---|---|
| Category | Water Pump |
| Impeller | Stainless Steel |
| Max Flow | Up to 1000 LPM |
| Max Head | Up to 50 m |
| Motor | TEFC |
| Phase | 3 |
| Frequency | 60 Hz |
| Material | Cast Iron |
| Shaft Seal | Mechanical Seal |
General safety warning regarding electrical hazards and preventing electrocution.
Details model series (TF 95/110) and maximum/minimum operating temperatures.
Covers enclosure protection (IP) ratings and required torque values for connections.
Step-by-step guide for connecting cables using the angle entry plug.
Instructions for preparing and connecting cables using the inline plug.
Specific wiring instructions for HEP Optimo Basic and BUPA/BGPA models.
Procedures for operating system valves and purging air from the system.
Explanation of night economy mode and LED signal meanings on the control knob.
Specific warnings about potential hazards from hot surfaces on the pump.
Graphical representation of pump performance (head vs. flow) for BUPA and BGPA models.
Pump performance curves for HEP Optimo models in various control modes.
Pump performance curves for HEP Optimo Geo models in various control modes.
Guide to diagnosing and resolving common pump issues like no running or loud noises.
Detailed warnings and procedures to prevent electrical shock during installation and operation.
Manufacturer's declaration that products comply with EU directives and standards.
List of global contact details for Armstrong Fluid Technology representatives.
