How to fix ARPWAVE Rx100 Medical Equipment if the machine won’t power on?
If the ARPWAVE Medical Equipment machine won’t power on, first, charge the battery or use the external power supply (AC adapter). Then, check the connection at the wall outlet. Finally, reposition the power plug to ensure a secure connection at the input power jack.
What to do if my ARPWAVE Rx100 Medical Equipment powers off during a session?
If the ARPWAVE Medical Equipment powers off (the touch screen goes blank) during a session, charge the battery or use the external power supply (AC adapter). You may also need to reposition the power plug to ensure a stable connection at the input power jack.
Why is the sensation intermittent in the pads of my ARPWAVE Medical Equipment?
To resolve intermittent sensation in the pads of your ARPWAVE Medical Equipment, ensure the Duty Cycle is set to CONT (continuous) and not cycling on and off.
What to do if patient discomfort after switching polarity on ARPWAVE Rx100 Medical Equipment?
If a patient experiences discomfort after switching polarity on the ARPWAVE Medical Equipment, turn the 'Output Power' down, switch the polarity, and then return the power setting to a level tolerable by the patient.
What to do if patient discomfort after changing Main Pulse Frequency on ARPWAVE Medical Equipment?
If a patient experiences discomfort after changing the Main Pulse Frequency on the ARPWAVE Medical Equipment, reduce the 'Output Power', switch the Main Pulse Frequency, and then adjust the power setting back to a level that is tolerable for the patient.
How to fix ARPWAVE Rx100 if main pulses turn on immediately?
If the main pulses turn on immediately instead of gradually on your ARPWAVE Medical Equipment, deactivate Sub-second mode by following the instructions on page 15.
What to do if there is no sensation in the pads of my ARPWAVE Rx100?
If you experience no sensation in the pads when using the ARPWAVE Medical Equipment, ensure the power switch is ON. Check if your authorized time credits are exhausted and request additional time if needed. Secure all connections, including the unit to the power supply box and the box to the power cord. Verify the wall outlet is functional and the wall switch is on. If using battery power, attach the battery to the DC receptacle. Test and replace any damaged or worn conductive pads. Reconnect any disconnected cables, ensuring the 'Output Power' is at zero before slowly adjusting it. Check cable connections and replace faulty cables. Adjust the 'Balance' to direct power to the correct jack. Confirm the 'Output Power' is appropriately turned up. Adjust the frequency and 'Output Power' if the...
Highlights the blend of two signals and patient participation for effective therapy.
Lists conditions for which the ARP Rx100 is approved for practitioner use.
Explains the signal type and polarity used by the ARP Rx100 device.
Lists conditions and patient groups for whom the device should not be used.
Provides essential warnings for safe and effective operation of the device.
Advises on necessary precautions for specific patient conditions and scenarios.
The first screen displayed after powering on the device.
Initial timer screen display when time value is 00:00.
Details the operation and safety guidelines for the AC adapter.
Instructions for installing and using the lithium-ion battery.
Procedure for recharging the lithium-ion battery.
General| Category | Medical Equipment |
|---|---|
| Model | Rx100 |
| Channels | 2 |
| Power Supply | AC 100-240V, 50/60 Hz |
| Pulse Width | 50 µs to 500 µs |
To Next Page