Media type not
supported
The media type of the current medium is
not supported.
Card 1/2: write
problem
The camera has problems writing to the
SxS PRO card in slot 1/2. Continue with a
fresh card.
Media write problem The camera has problems writing to the
recording medium. Continue with a fresh
medium.
Media: wrong
recording mode. May
contain clips
XR Capture Drive is formatted for
ARRIRAW, but ALEXA is in ProRes
recording mode, or vice-versa. Format the
media to record on it.
Camera overheating The camera system's temperature is
reaching a critical level. This can either be
due to a blocked camera fan or ambient
temperature exceeding the system's limits.
Apply additional cooling or switch off the
camera to prevent hardware damage.
Low sensor
temperature
The sensor temperature is lower than it
should be. High image quality is still
guaranteed.
High sensor
temperature
The sensor temperature is higher than it
should be. High image quality is still
guaranteed.
Ext TC: Different
frame rate
The external TC signal's time base differs
from the project fps of the camera. Syncing
is still possible.
Re-jam timecode
soon.
Accuracy of jammed Timecode can soon
expire. Re-jam camera with external
Timecode soon.
Re-jam timecode
now.
Accuracy of jammed Timecode has expired.
Re-jam camera with external Timecode.
TC source forced to
internal
Sensor fps does not match Project fps.
External Free Run TC cannot be used,
camera has switched to Int Rec Run TC.
TC mode forced to
Rec Run
Sensor fps does not match Project fps.
External Free Run TC cannot be used,
camera has switched to Int Rec Run TC.
Interface bit error.
Check image.
Reboot camera. If error continues to occur,
contact ARRI service.
Internal processing
problem
Reboot camera. If error continues to occur,
contact ARRI service.
Internal battery error The internal battery which powers the real-
time clock must be replaced. Contact an
ARRI service center near you.
System problem Reboot the camera. If error continues to
occur, contact ARRI service.