26
Step 13
A26
● Parts Needed For ●
Right Roof Panel
●●
●●
● 8468 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner of
the building. Each screw and bolt in
the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square.
This will make the roof panels fit
better, and holes will align.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels by their
numbers.
Note the sequence and
position they are to be installed.
2 Position the right roof panel at the
back right corner and fasten to the
gable with 5 bolts and nuts and roof
beams using 2 screws.
Do not fasten
the lower end of the panel to the side
wall angle at this time.
Hint: Attach fasteners in order shown
in diagram.
8468 Right Roof Panel
FRONT
Washer
Bolt
Gable
STEP
2
STEP
1
Nut
1
2
3
4
5
6
7
8469
7483
7483
8468
8469
7483
7483
8468
8
6
2
4
1
5
7
3
FRONT
6529
6529
10
9
To Next Page
Loading...
