ARSEGAN Easybrew-50 - Malt Pipe and Overflow Pipe Configuration

Brouwmarkt BV, Markerkant 1111, 1316 AE Almere
www.braumarkt.com
Malt pipe and overow pipe
1 x top malt screen
(1 centre hole + 2 small holes)
1 x bottom malt screen
(1 centre hole)
2 x double female thread
connector
1 x single female thread
connector
1 x male thread connector
2 x handle
1 x short pipe
1 x white plastic cap
1 x long pipe
1. Put the male thread connector (H) through bottom malt screen (B) and attach it with 1 double
female thread connector (F).
2. You can adapt the overow pipe according to the amount of malt recommended for your
recipe. For a large amount of malt you can use Mode 1. For a small amount of malt you can
use Mode 2.
Attach long pipe (E)
Attach short pipe (D)
Methode 2
B
C
D
F
G
H
I
E
A
A
B
C
D
E
F
G
H
I
Mode 1 Mode 2