Artel NCA115-2A - Remote Control; Remote Control Operation and Battery

11 of 36
EN
The remote control (Fig. 3) used to adjust water temperature
power and the on/off functions for the pellet pellet insert.
To start the pellet insert, press key and the pellet insert
will automatically enter the starting phase.
Press keys + (1) and - (2) to adjust temperature, and use
keys + (6) and - (5) to adjust operating power.
To turn off the pellet insert, hold down key
.
To replace the 3 volt battery located on the back of the
remote control, pull the centre of the cover and the lever
on the side of the same, replace the battery observing the
correct polarity (Fig. 4)
Remote Control
Fig. 3
Fig. 4