Artel NCA115-2A - Technical Performance Data; Performance Parameters Table

14 of 36
EN
It is recommended that emissions are checked after installation.
To obtain the test report results, load the performance parameters in the possession of the
manufacturer and the technician, who can only use them after checking that the installation
is able to reproduce the laboratory conditions. These performances are only achievable after
15/20 hours of operation at rated power.
PARAMETER
UNIT OF
MEASURE
NCA115-2A NCA150
Heat input
kW 13,1 14,9
Nominal heat output
kW 11,6 13,1
Reduced heat output
kW 5,6 5,6
CO concentration at nominal
reference (13% O
2
)
mg/m
3
130 120
CO concentration at reduced
reference (13% O
2
)
mg/m
3
229 229
Nominal efciency
% 88,8 88,3
Reduced efciency
% 90 90
Average consumption Kg/h 1,24 - 2,63 1,24 - 2,99
Heatable surface mc 260 300
Flue gas ow rate (min-max)
g/s 5,72 - 9,69 5,72 - 10,45
Draft advised (min-max)
Pa 3 - 5 3 - 8
Flue gas temperature (min-max)
°C 123 - 164 123 - 178
Tank capacity
Kg 18 18
Diameter smoke outlet tube
mm 80 80
Diameter air intake
mm 50 50
Nominal voltage
V 230 230
Nominal frequency
Hz 50 50
Ignition power consumption W 290 290
Electrical consumption (max-min) W 100 - 35 105 - 35
Pellet insert weight
Kg 108 120
Powders at 13% O2 Ref.
nominal heat output
mg/m
3
20 20
Energy Class A +
IEE 125 124
Environmental Certicate
Decree n° 186 del 7/11/2017
N° Test Report K 3097 2021 T1