WARNING: Do not use a damaged or nonr
ecommended power cord with your switch. Using such
power cords voids the switch and power supply warranty. It can also cause serious electrical problems,
including injury or death to personnel, and damage to the switch and other property. If you cannot
verify that you have a power cord approved for use with your switch model, contact your authorized
Aruba dealer or sales representative for assistance.
WARNING: Remo
ve all power cords from the switch before mounting or dismounting the switch.
Japan power cord
warning
Aruba 6400 Power Supply safety and regulatory information
NOTE: For important safety
, environmental, and regulatory information, see Safety and Compliance
Information for Server, Storage, Power, Networking, and Rack Products, available at
http://www.hpe.com/
support/Safety-Compliance-EnterpriseProducts.
Table 1: Electrical information for Aruba modular po
wer supplies using direct AC voltage
Switch product SKU Maximum current per
power supply
AC voltage Frequency
range
Any Aruba 6405 Switch populated with the
R0X35A 1800W power supplies and C16
inlet adapters
12A for 110-127VAC
10A for 200-240VAC
110-127 /
200-240
50/60 HZ
Any Aruba 6405 Switch populated with the
R0X36A 3000W power supplies and C20
inlet adapters
16A for 110-127VAC
16A for 200-240VAC
Any Aruba 6410 Switch populated with the
R0X35A 1800W power supplies and C16
inlet adapters
12A for 110-127VAC
10A for 200-240VAC
Any Aruba 6410 Switch populated with the
R0X36A 3000W power supplies and C20
inlet adapters
16A for 110-127VAC
16A for 200-240VAC
NOTE: The C16 inlet adapters are designed to operate with the R0X35A (1800W) power supplies, and
the C20 inlet adapters are designed to operate with the R0X36A (3000W) power supplies. For more
information on power supply and inlet adapter operation, see the latest Installation and Getting
Started Guide for your switch model.
Page 3
To Next Page
Loading...
