4 Aruba 310 Series Access Points | Installation Guide
Figure 3 External Antenna Connectors
Antenna ports ANT0 and ANT1 are connected to a dual-band radio and support 2.4GHz and 5GHz. The ANT2 and
ANT3 antenna ports support 5GHz only.
Bluetooth Low Energy Radios
310 Series access points are equipped with an integrated BLE radio that provide the following capabilities:
location beacon applications
wireless console access
Console Port
The console port allows the user to connect to the access point directly to a serial terminal or laptop for local
management. Connect the device to a terminal or terminal server using an AP-CBL-SERU cable. For pin-out
details, refer to Figure 4.
Figure 4 Console Port Pin-out
Ethernet Ports
The Aruba 310 Series is equipped with a 10/100/1000Base-T auto-sensing MDI/MDX Ethernet port. The port
supports wired-network connectivity, in addition to Power over Ethernet (PoE) from IEEE 802.3af and 802.3at
External antennas for this device must be installed by an Aruba Certified Mobility Professional (ACMP) or other
Aruba-certified technician, using manufacturer-approved antennas only.
The Equivalent Isotropically Radiated Power (EIRP) levels for all external antenna devices must not exceed the
regulatory limit set by the host country/domain.
Installers are required to record the antenna gain for this device in the system management software.
Les antennes externes pour cet appareil doivent être installées par un professionnel de la mobilité certifié Aruba
(ACMP) ou un autre technicien certifié Aruba, en utilisant uniquement des antennes approuvées par le fabricant.
Les niveaux équivalents de puissance à rayonnement isotrope (EIRP) pour tous les périphériques d'antenne
externe ne doivent pas dépasser la limite réglementaire définie par le pays hôte / domaine.
Les installateurs doivent enregistrer le gain d'antenne pour cet appareil dans le logiciel de gestion du système.
1: NC
2: RX
3: TX
4: GND
5: GND
1 3.3V
2 RX
3 TX
4 GND
Pin Signal
To Next Page
