TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
124
6 Click “OK”
If, by way of exception, the route for a Map entry is to be configured with a different
destination than that specified in the route's destination field, you can select this from the
Destination field of the “Map”.
Add CGPN map
1 Select Gateway > Routes.
Leave all the remaining fields blank, in the normal case.
• Final Route Enable if the routing shall stop here
• Final Map Enable if the mapping shall stop here.
• No Reroute on wrong No Enable if you don’t want to reroute when call fails due
to wrong number.
• Verify CGPN Map will match only if there is a matching CGPN map
too.
• Interworking (QSIG, SIP) Enable to support supplementary services (such as
name display, call transfer, call diversion etc.)u between
the H.323/SIP network and a QSIG network.
• Rerouting as Deflection Enable if "call rerouting" supplementary service shall
be implemented as "call deflection".
• Routing on Diverting No Enable if routing shall be done based on diverting
number (diverting leg2 info).
• Force enblock Enable to send call en-block after 4 seconds interdigit
timeout.
• Add # A # can be transmitted to mark the end of the call
number. This is required for devices, such as from
Cisco, which are unable to identify the end of a
number properly.
• Disable Echo Canceler
• Call Counter A name for resource management can be entered.
• Max Limits the number of permitted calls for a route.
To Next Page
Loading...