TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
89
Figure 28. The DECT System configuration page
8.5.1 Change System Name and Password
Note: This is only applicable for a Master, never on a Slave.
The system name and password must be the same for all IPBS/IPBLs throughout the
system. Reset in order to make the changes take effect, see 8.22 Reset on page 138.
Note: If Ascom VoIP Gateway is the LDAP server, the password in the IPBS/IPBL must be
identical to the Ascom VoIP Gateway (PBX/Password).
1 Select DECT > System.
Note: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 Write a system name in the System Name text field.
3 Enter a new password in the Password text field. Repeat the password.
4 Click "OK".
Note: It is recommended to create a backup of the IPBS configuration when the password
has been changed, see
8.14 Backup on page 126.
8.5.2 Set Subscription Method
The IP-DECT system can be set to use the following subscription methods:
• With User AC - Individual Registration and Auto Registration is possible.
• With System AC - Anonymous Registration and Individual Registration is possible.
• Disable - Registration is not possible.
Select subscription method:
To Next Page
Loading...