TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
139
Long press ~ 10 sec.
For IPBS2: When 10 sec.
has gone, the LED on
IPBS2 will start to flash in
blue, indicating the start
of the factory reset
process. Hence the reset
button can then be
released.
When the LED (LED 1 for
IPBS1) is steady amber/
yellow, the factory reset
process is complete. The
device can now be
restarted by
disconnecting the supply
voltage.
Factory reset - all configuration parameters will be set to
default values.
To Next Page
Loading...