22
ACK-E-2009 Application Information
Panel Installation
The front panel can only be fi tted in one direction, follow the piping direction. (Follow piping arrow sticker
on the front panel).
Be sure to remove the installation template before installing the front panel.
Open the air intake grille by pulling back the catchers and remove it together with fi lter from panel.
Install the front frame panel onto the indoor unit by using 4 screws and tighten it completely to prevent cool
air leakage.
Connect the LED wire and air swing wire to the indoor unit (Optional).
Note: Install the front frame panel fi rmly to prevent cool air leakage which will cause condensation
and water dripping.
•
•
•
•
•
05_Application Information_A.ind22 2205_Application Information_A.ind22 22 4/6/2009 3:32:53 PM4/6/2009 3:32:53 PM
To Next Page
Loading...