7
ELECTRONIC CENTRIFUGAL CASTING MACHINE MODULAR 6
Centrifugal casting into flask
This electronic induction centrifugal casting machine has been built using the best technology and has a control
lay-out which is very operator-friendly.
It is designed for melting and casting the following alloys for dental use:
•
precious and non precious alloys for ceramic and resin
•
chrome cobalt molybdenum.
With the temperature controller it is possible to read and hold the casting temperature, obtaining the complete
fluidity of the metal which will be cast into the flask during centrifugation and reach the thinnest part of the model.
To facilitate the molten alloys to smoothly flow out of the crucible during spinning the MODULAR 6 fits a
sloping crucible holding plate which also ensures a complete and smooth flow of those alloys with a low specific
weight. The MODULAR 6 fits a universal flask cradle i.e. with an easy movement of the lever it is possible to
adjust the flask support and any sprue button of the flask will be easily centered with the crucible exit hole. This
universal cradle is particularly suitable when using the technique of the free expansion without metal casting rings
.Normally 5 standard flask sizes are used; the smallest flask size of 30 mm diam. must be inserted in the ceramic
container given as normal outfit and both of them must be put in the burn-out furnace. This ceramic container will
maintain a constant temperature of the small flask during spinning.
ATTENTION: This machine must be only utilized for the intended purpose in accordance with the
seller’s instructions. Any other use is to be considered improper and consequently dangerous. The
manufacturer cannot be held liable for any damages caused for improper, wrong and unreasonable
uses.
ATTENTION: The use of non-genuine crucible which do not correspond to the parameters of the
machine final test will considerably shorten the life of the power generator.
TECHNICAL CHARACTERISTICS
Electrical singlephase 3 kW - see nameplate
Dimensions and Weight 600 mm w x 680 mm d x 930 mm h - 106 Kg
Frequency 80 KHz
Crucible capacity precious alloys max. 80 gr
chrome-cobalt molybdenum from 15/20 up to
100 gr
Flasks 30 mm diam. x 50 mm h. - to be used with
ceramic container A100.001
50-70-80-90 mm diam. x 55 mm h.
Water cooling 2 litres/m’ - 3 bar
MODULAR 6
To Next Page
Loading...