Ashley CAC - User Manual

24 pages

Save Page as PDF

To Next Page

* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.

THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.

Owner’s Instruction and Operation Manual

SAFETY NOTICE: If this heater is not properly installed, a house re may result.

For your safety, follow the installation instructions. Never use make-shift

compromises during the installation of this heater. Contact local building or

re ofcials about permits, restrictions and installation requirements in your

area. NEVER OPERATE THIS PRODUCT WHILE UNATTENDED.

CAUTION! Please read this entire manual before you install or use your new room

heater. Failure to follow instructions may result in property damage, bodily injury,

or even death. Improper Installation Will Void Your Warranty!

Save These Instructions In A Safe Place For Future Reference.

CALIFORNIA PROPOSITION 65 WARNING:

This product can expose you to chemicals including carbon

monoxide, which is known to the State of California to cause

cancer, birth defects, and/or other reproductive harm. For

more information, go to www.P65warnings.ca.gov

Model Number:

CAC/BCAC

COAL ONLY STOVE

851396K-0102K

Report #: F20-574

This unit was tested and listed to UL 1482-1996.

DO NOT USE THIS HEATER IN A MOBILE

HOME OR TRAILER

Questions and Answers

L
Larry GoodmanAug 4, 2025
Why does my Ashley CAC Stove smoke or burn poorly, or why is there excessive creosote in the chimney?
- D
  Dean BowenAug 4, 2025
  Several factors can cause your Ashley Stove to smoke, burn poorly, or accumulate excessive creosote. It could be due to a slight vacuum in the room; try opening a window slightly to see if conditions improve. The issue might also be loss of air from the room through kitchen or bathroom fans, chimneys, or vents; reduce air loss or provide an air source. Check the pipes connecting the heater to the chimney for loose or unsealed joints that leak air, and inspect the chimney for cracks or holes. Review your fire-building method, check for obstructions in the system, ensure the chimney height is adequate, and verify the chimney flue liner size.
M
Madison HortonAug 17, 2025
What to do if my Ashley CAC burns too rapidly or overheats?
- C
  cherylvincentAug 17, 2025
  If your Ashley Stove is burning too rapidly or overheating, it could be due to several reasons. First, adjust the amount of fuel you're using based on the outdoor temperature. If that doesn't solve the problem, check for air leaks around the door gasket or feed/ash door. Finally, excessive draft could be the cause; consider purchasing a barometric damper for installation in the chimney connector.

Summary

Safety Notices and Warnings

Installation Safety Notice

Safety notice regarding proper installation and unattended operation.

General Cautionary Advice

Caution to read the manual before installation/use to prevent damage or injury.

California Proposition 65 Warning

Warning about exposure to chemicals like carbon monoxide.

Introduction

Heater Specifications and Dimensions

Details the stove's physical and operational specifications and dimensions.

Important Operating Cautions

Lists critical safety and operational warnings for fire use.

Installation Checklist

Commissioning and Installation Details

Checklist sections for commissioning, work description, and declarations.

Installation Guidance

Building Codes and Safety Standards

Advice to consult local officials for compliance with building codes and regulations.

Heater Operation Overview

Explains how the heater's airflow and heat transfer mechanism works.

Selecting a Heater Location

Factors to consider when choosing a safe and effective location for the heater.

Installation: Clearances and Floor Protection

Floor Protection Requirements

Details required non-combustible floor protectors and their placement.

Clearance Diagrams and Dimensions

Visual guide showing minimum clearances to combustible materials.

Installation: Chimneys and Connectors

Factory-Built Chimney Installation

Instructions for installing listed factory-built chimneys.

Chimney Connector and Masonry Chimney Connections

Guidelines for connecting the heater to chimneys, including types and materials.

Installation: Chimney Connections to Masonry

Masonry Chimney Wall Pass-Throughs

Describes five allowable methods for passing a connector through a combustible wall.

Factory-Built Chimney Connection Details

Specifics on using listed factory-built chimney sections for connections.

Installation: Chimney Connector Requirements

Specific Chimney Connector Types

Details on using insulated chimney sections and thimbles for connections.

Wall Pass-Through System Requirements

Additional requirements for wall pass-through systems and openings.

Installation: Final Steps and Inspection

Metal Prefabricated Chimney Installation

Guidance on installing metal prefabricated chimneys and maintaining clearances.

Heater Inspection Before Installation

Steps for inspecting the heater for damage and missing parts before installation.

Tools and Supplies for Installation

Lists necessary tools and supplies for the installation process.

Installation: Clearances and Protection

Minimum Clearances to Combustibles

Details minimum clearances to walls, ceilings, and combustible materials.

Clearance Reduction Systems

Explains systems to reduce clearances and their requirements.

Installation: Assembly and Connections

Chimney Connector Assembly Steps

Step-by-step instructions for assembling and securing the chimney connector.

Connecting to Masonry Fireplaces

Guidance on connecting the heater to masonry fireplaces or chimneys.

Operation

Never Operate Unattended

Critical warning against operating the heater without supervision.

Initial Heater Firing and Curing

Instructions for the first few fires to cure paint and allow components to adjust.

Building a Fire

Step-by-step guide on how to properly start a fire in the heater.

Operation: Fuel Feed and Control

Adding Coal and Fire Tending

Guidance on adding coal, fire tending, and proper door closure.

Thermostat Control Adjustment

How to set and adjust the thermostat for desired heat output.

Fuel Feed Door Operation

Detailed instructions on opening and closing the fuel feed door.

Operation: Fire Tending and Refueling

Fire Tending Safety Rules

Rules to follow during fire tending and refueling to prevent overheating and damage.

Refueling and Backpuffing Prevention

Guidance on refueling, preventing backpuffing, and minimizing soot.

Minimum Fire Adjustment

How to adjust the air shutter for minimum fire to control soot accumulation.

Operation: Coal Facts and Firing

Air Shutter Adjustment

How to adjust the air shutter for optimal fire control and soot reduction.

Coal Types and Characteristics

Information on anthracite and bituminous coal, their properties, and storage.

Maintenance

Heater and Venting System Care

Routine maintenance for the heater's cabinet, gaskets, and venting system.

Disposal of Ashes

Proper procedures for removing and storing ashes safely.

Soot Formation and Removal

Information on soot formation, risks of chimney fires, and cleaning.

Maintenance and Troubleshooting

Chimney Connector Pipe Corrosion

Inspection and potential replacement of chimney connector pipes due to corrosion.

Venting System Performance

How the venting system affects heater performance and draft.

Troubleshooting Poor Draft or Smoke Spillage

Identifying and resolving issues causing poor draft or smoke spillage.

Troubleshooting Common Problems

Room Vacuum and Airflow Issues

Diagnosing and resolving issues caused by room vacuum or air leaks.

Chimney Obstructions and Flue Size

Checking for chimney obstructions and proper flue liner size.

Heater Overheating Causes

Identifying reasons for the heater burning too rapidly or overheating.

Troubleshooting and Final Checks

Quick Reference for Operational Problems

Table summarizing common symptoms and their potential causes.

Final Checklist: Dos and Donts

Essential do's and don'ts for safe installation and operation.

Troubleshooting: Dos and Donts

Operation Dos and Donts

Comprehensive list of recommended practices and prohibitions for operation.

Safety Notice on Overfiring

Warning and guidance regarding heater overfiring and potential solutions.

Parts Diagram

Heater Component Identification

Visual representation of all heater components with numerical labels.

Parts List

Component Part Numbers and Descriptions

Detailed list of part numbers, descriptions, and quantities for ordering replacement parts.

Service Record

Service Provider Log

Forms to record details of professional servicing and chimney sweeping.

Notes

Blank Notes Section

Empty section for user notes and record keeping.

Ashley CAC Specifications

General

Brand	Ashley
Model	CAC
Category	Stove
Language	English

Related product manuals